Yesterday and today I was printing two 30 cm. tall tree trunks - or so I thought!When I entered the hobby room after dinner today, the hotend was drawing lines above an unfinished stump, and it was soon obvious that I had a severe filament clog.
It took me over half an hour to get the filament flowing (changed the spool back to the darker grey which worked fine yesterday, just to make sure), and now the printer is up and running once more!
I am planning to start my largest print so far, either later today or tomorrow (est. 27hs 19ms); the upscaled (575%) X-wing escape pod for all kinds of Star Wars settings (and a certain pair of droids to get away in).
Where did you get the stl for this?
ReplyDeleteThingiverse:
Deletehttps://www.thingiverse.com/thing:2853566