Sunday, 2 September 2018

3D Printed: Star Wars Scatter Terrain

Smaller pieces to populate the Star Wars Legion table printed so far (the Imperial bunker and the power-thingies not included). Everything off Thingiverse.

Currently printing a 30cm redwood (jungle/Endor), and when it finishes this evening, I shall have to change filament to a lighter grey for printing some additional commission pieces for Imperial Assault.

Later this week I shall try my largest print so far, an escape pod, scaled up from a Thingiverse X-wing scale model (I ordered C-3PO, and R2-D2, yesterday, and am going to make a large dune with an indent for the escape pod, so I can stage an Ep. IV Tatooine display).

No comments:

Post a Comment